I have already done all the troubleshooting many times over and even fully exchanged both Ring Alarm Pro and All Eero 6 pro access points

I believe the firmware has an issue with Apple devices that are in a “sleep” state.

When picking up a device (iPhone,iPad, etc) or start using an Apple TV, there is a noticeable delay before the connection kicks in. Almost like the eero has to acknowledge the device is active again. Most of the time you have to refresh a few times to get it going.

In the app you can even see the signal bounce down on sleeping Apple devices and bounce back to full bars once you finally get an activity going again on the device.

I’m positive I’m not the only one experiencing this.