0

DHCP settings and range

Hi- I would like to replicate the above (apple extreme) settings in my first time newly installed eero pro 6e gateway which i have just installed.

Question: do i accomplish this by picking Manual IP, changing IP address prefix to 10.0.0.0 and appropriately changing the lease ranges?  Even though it says "manual IP", devices without static IP addresses will still get assigned dynamically by the router, correct?  Thanks!

3 replies

    • Michael_eero_support
    • 1 yr ago
    • Reported - view

    Hi  Greetings from eero!

    You have it mainly correct.  eero will still be automatically generating and assigning addresses.  The manual in this instance is you are setting the range manually instead of allowing the eero to do it automatically.

    So, go to eero app->Settings->Network Settings->DHCP & NAT, move the dot to Manual, select the 10.0.0.0 prefix and put in the follwoing numbers:

    Subnet IP: 10.0.1.0

    Subnet mask: 255.255.255.255.0

    Staring IP: 10.0.1.2

    Ending IP: 10.0.1.254

    and click save.

     

    The Apple extreme will have to be off once you make these changes.  You can't run two routers using the same IP range.  They will kick each other offline and things will be an example of the term: unstable.

     

    Thanks,

      • Aknyc
      • 1 yr ago
      • Reported - view

       yes that worked.  My Apple extreme had subnet mask 255 255 254 0 which the eero didn’t like so I went with 255 instead of 254.  Not sure what the difference is.

       

      I have set the Apple extreme to bridge mode so that I can access the disks attached to it via usb.  Would be nice if eero had this feature!

      another question- I have 4 eero pro 6e’s as “wired (via Ethernet) waps”.  Can I schedule them to go on and off individually? (For example turn off the one near the baby room at night?)

       Thanks!

      • Michael_eero_support
      • 1 yr ago
      • Reported - view

       eero does not have the ability to schedule to go on/off at certain times.  If you want to do that you would need to use programmable power plugs.

Content aside

  • 1 yr agoLast active
  • 3Replies
  • 4187Views
  • 2 Following